3 VALVE ASSEMBLY
Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks.
Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4) into mounting holes from underside of ledge.
Press TEE (5) onto SPOUT SHANK (6) making certain that the
9
MOUNTING 11
SURFACE
10
Thread of VALVE BODY (4) should extend at least 5/16 inch above MOUNTING SURFACE (11). If necessary, adjust LOCKNUT (1).
Place RUBBER RING (10) into ESCUTCHEON ADAPTERS (9) and thread onto valves until snug against internal stop.
Tighten LOCKNUT (1) to secure VALVE (4) position.
Slide FERRULE (12) and COUPLING NUT (13) to outlet of VALVE (4) and tighten COUPLING NUT (13) firmly.
9 
10 
4
Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of right VALVE using appropriate connector.
9
10
12
7
13 6
5/16'' MIN. | 4 |
|
| HOT |
| |
11 | MOUNTING | 12 | 4 | |||
|
| |||||
|
|
| SURFACE | 3 |
| |
|
| 2 |
| 5 |
| |
|
|
| 8 |
| ||
|
| 1 |
|
| ||
|
|
|
|
| ||
|
|
|
| 13 | COLD |
4 INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without spline is facing up. See figure "A".
Thread HANDLE BASE (3) onto DECK ADAPTER (7)
Push HANDLE (4) onto ADAPTER (1). |
| TOP |
Find correct position of HANDLE (4) by adjusting male teeth on |
| |
ADAPTER (1) to female teeth in HANDLE (4). |
|
|
Secure HANDLE (4) with HANDLE SCREW (5). | Figure "A" |
|
|
| |
Push INDEX CAP (6) in hole of HANDLE (4). |
|
|
| SPLINE END DOWN | 2 |
|
| |
6
5
4
3
1
7
5 SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Pull out INDEX CAP (1) and remove HANDLE SCREW (2).
Pull off HANDLE (3), and unscrew ESCUTCHEON (4).
Pull off STEM ADAPTER (7).
Remove SPRING CLIP (6).
Lift STOP WASHER (5), turn 90° and replace.
Replace SPRING CLIP (6) and STEM ADAPTER (7). 
Reinstall ESCUTCHEON (4) and HANDLE ASSEMBLY (1,2 & 3).
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90° .
1
2
3
4
90° | 7 |
| |
| 5 |
6
M 9 6 8 2 1 2
