American Standard 3099.016 dimensions Cadet Elongated PRESSURE-ASSISTED Toilet, 2333.100

CADET™ ELONGATED

PRESSURE-ASSISTED TOILET

❏2333.100

•Vitreous china

•Low-consumption (6.0 Lpf/1.6 gpf)

•Elongated bowl

•Pressure-assisted siphon jet flush action

•Fully-glazed 2" ballpass trapway

•10" x 12" water surface area

•Side-mounted chrome trip lever

•Close-coupled flushometer tank*

•Speed Connect® tank/bowl coupling system

•2 bolt caps

•100% factory flush tested

❏3099.016 Bowl with two bolt caps

❏4098.100 Tank complete with coupling components

Nominal Dimensions:

CADET™ ELONGATED PRESSURE-ASSISTED TOILET

VITREOUS CHINA

787 x 495 x 737mm (31" x 19-1/2" x 29")

Fixture only, seat and supply by others

Recommended working pressure range 20 psi - 80 psi

Alternate Configurations Available:

❏3099.203 Elongated bowl only with slotted rim for bedpan holding

❏4098.700 Tank and tank cover only with tank cover locking device

❏4098.800 Tank and tank cover only with right hand trip lever

❏4098.900 Tank complete with right hand trip lever and tank cover locking device

Compliance Certifications -

Meets or Exceeds the Following Specifications:

• ASME A112.19.2 for Vitreous China Fixtures

FINISHED WALL
		31
		(787mm)
3/4 ± 1/4
(19mm	± 6mm)
		225mm
		(8-7/8)
		18-1/2
		(470mm)
		C/L OF SEAT POST HOLES
		5-1/2 (140mm CENTERS)
1/4-3 (83mm)			14
			(356mm)
		5/8
		(16mm)	FINISHED
		13
5-3/4			FLOOR
		(330mm)
(146mm)
12
(305mm)		C/L OF OUTLET

19-1/2

(495mm)

29

SUPPLY(737mm)

AS

REQ'D

15

*8 (381mm) (203mm)

*6

(152mm)

9-3/4

(248mm)

To Be Specified:
❏ Color: ❏ White	❏ Bone	❏ Linen
❏ Silver	❏ Fawn	Beige ❏ Black

❏Seat: American Standard #5324.019 “Rise and Shine" (with easy to clean lift-off hinge system) solid plastic closed front seat with cover.

❏Seat: American Standard #5311.012 “Laurel" molded closed front seat with cover.

❏Alternate Seat:

❏Supply with Stop:

* Flushmate III tank system by Flushmate® Div. of Sloan Valve Co © 2008 AS America Inc.

NOTES:

THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DI- MENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.

*DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED. SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.

FOR ADDITIONAL INFORMATION REFER TO INSTALLATION INSTRUCTIONS SUPPLIED.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

M46

Revised 2/08