2 SPOUT INSTALLATION
Insert SPOUT SHANK (1) through sink hole.
Make sure RUBBER RING (2) is properly seated in recess
3
HAND SPRAY INSTALLATION
Note: For installation less spray, cap off THREADED STUD with PIPE CAP.
Place SPRAY HOLDER (1) into separate hole of SINK and assemble WING NUT
of ESCUTCHEON (3).
Center SPOUT ESCUTCHEON (3) and tighten WING NUT(4) firmly.
Connect SPOUT HOSE (5)
to SPOUT SHANK (1). (SPOUT HOSE is connected to 1 VALVE BODY already).
3
2
4
5
(2)onto SHANK from
underside of SINK and tighten.
Feed SPRAY HOSE (3) through HOLDER (1) and attach COUPLING
(4) to THREADED STUD of VALVE. Tighten COUPLING NUT (4) firmly.
4
1
2
3
7
6
5
8
SPRAY HOSE
Make certain that SPACER WASHER (5) and RUBBER WASHER (6) are attached to SPRAY HOSE (3) and thread SPRAY HEAD (7) to NUT (8).
4 CONNECT SUPPLIES
Bend TUBES to meet supplies. Use palm of hand to support TUBES while bending to avoid kinking.
OR
Connect
5 TEST INSTALLED FAUCET
Move handle down into "off" position, remove AERATOR.
With HANDLE in "off" position, turn on water supplies and check all connections for leaks.
Operate handle up and down, in COLD and HOT positions, to flush water lines thoroughly and check spout mounting for leaks.
Direct SPRAY HEAD into sink. Open faucet and activate spray. Check SPRAY HOSE connections for leaks.
Move handle down into "off" position and replace AERATOR.
6 SERVICE
AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean.
If SPOUT drips, operate handles several times from OFF to ON position. Do not force - handle.
HOT LIMIT SAFETY STOP ADJUSTMENT
By restricting handle rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP reduces risk of accidental scalding. To set the maximum hot water temperature of your faucets, all you need to do is adjust the setting on the HOT LIMIT SAFETY STOP.
Remove HANDLE BUTTON (1) and loosen SET SCREW (2). Pull |
| |
HANDLE (3) off valve stem. Pull off CAP (4). Use a flat blade | "B" | |
screwdriver or your fingers to pull up and rotate red | ||
| ||
HOT LIMIT SAFETY STOP (5). Follow Step "A" or "B" to adjust |
| |
min./max.discharge temperature. "0" being the hottest to | "B" | |
"7" the coldest temperature setting. Factory set at "0". |
ADJUSTMENT WHEN Replace ESCUTCHEON CAP (4), HANDLE (3), tighten WATER IS TOO COLD HANDLE SCREW (1) and install INDEX BUTTON (2).
"A"
PRY RED RING FORWARD
AND ROTATE COUNTER-
CLOCKWISE ONE CLICK
"A"
"A"
|
|
|
| 0 | ADJUSTMENT WHEN |
|
|
| 1 |
|
|
4 |
| 2 |
|
| WATER IS TOO HOT |
3 |
|
|
|
5 6
6
5
"RED RING"- HOT LIMIT SAFETY STOP
M968150 REV . 1 . 1