American Standard 4019.800, 4019.600, 4019.900 dimensions CADET 3 ROUND FRONT ROUGH-INTOILET, Tank

CADET® 3 ROUND FRONT 10"

ROUGH-IN TOILET

VITREOUS CHINA

CADET® 3 ROUND FRONT 10"

ROUGH-IN TOILET

❑2384.010

•Vitreous china

•Low-consumption (6.0 Lpf/1.6 gpf)

•EverClean® surface inhibits the growth of stain- and odor-causing bacteria, mold, and mildew on the surface

•Features the Cadet® 3 Flushing System

•Space saving round front siphon action jetted bowl

•Fully-glazed 2-1/8" trapway with 2" ball pass

•Generous 9" x 8" water surface area

•Close-coupled tank with flat tank cover for superior storage

•Oversized 3" flush valve with chemical resistant flapper

•Chrome trip lever

•Speed Connect® tank-to-bowl coupling system

•Sanitary dam on bowl with four point tank stabilization

• 2 color-matched bolt caps	SEE REVERSE FOR ADDITIONAL ROUGHING-IN
• 100% factory flush tested
	DIMENSIONS
• 5 year warranty
❑ 3011.016 Round Front Bowl
	To Be Specified:
❑ 4019.016 Tank
	❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black
Nominal Dimensions:	❏ Seat: #5330.010 Round front Champion® Slow Close
	solid plastic seat and cover with easy lift off feature
667 x 432 x 740mm
	❏ Seat: #5282.011 Round Front EverClean® solid plas-
(26-1/4" x 17" x 29-1/8")	tic seat and cover
	❏ Seat: #5320.110 EverClean® Round Front Seat with
Fixture only, seat and supply by others	Slow Close Snap-Off Hinges
	❏ Supply with stop:

Alternative Tank Configurations Available:

❑4019.600 Tank complete with tank cover locking device

❑ 4019.800 Tank complete with trip lever on right side

❑ 4019.900 Tank complete with tank cover locking device and trip lever on right side

Compliance Certifications -

Meets or Exceeds the Following Specifications:

•ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

•Los Angeles Department of Water and Power Supplementary Purchase Specification for Non-Adjustability

© 2008 AS America Inc.

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 254MM (10") FROM FINISHED WALL TO C/L OF OUTLET.

SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.

*DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2.

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

K69

Revised 2/08