2 MAKE WATER SUPPLY CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR
Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D.
Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.
1
1
2
COUPLING NUT
3
FERRULE
3 TEST INSTALLED FITTING |
|
|
| |
With HANDLES (1) in OFF position, turn on WATER |
|
|
| |
SUPPLIES (2) and check all connections for leaks. | 4 |
| 3 | |
Remove AERATOR (3). | 1 | |||
|
| |||
|
| 5 | ||
Operate both HANDLES to flush water lines thoroughly. |
|
| ||
1 |
|
| ||
Rotate SPOUT (4) in both directions. |
|
|
Replace AERATOR (3).
Direct SPRAY (5) into sink and activate. Check hose connections for leaks. 
| 2 |
|
4 SERVICE |
| 1 |
| 2 | |
To change direction of handle rotation, proceed as follows: |
| 3 |
Turn valve to OFF position. |
| |
|
| |
Pull out INDEX CAP (1) and remove HANDLE SCREW (2). |
|
|
Pull off HANDLE (3). |
|
|
Pull off STEM ADAPTER (4). |
|
|
Remove SPRING CLIP (6). | 90° | 4 |
Lift STOP WASHER (5), turn 90° and replace. |
| |
Replace SPRING CLIP (6) and STEM ADAPTER (4). |
| 5 |
Reinstall HANDLE ASSEMBLY (1,2 & 3). |
|
|
If spout drips, operate handles several times from OFF to ON position. | 6 |
|
Do not force - handles turn only 90° . |
|
|
5 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M968413
