9 TEST INSTALLED FITTING
| 4 |
| 1 |
With HANDLES (1) in OFF position, turn on WATER |
|
| |
|
SUPPLIES (2) and check all connections for leaks.
1
Remove AERATOR (3).
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3).
CHECK DRAIN CONNECTIONS |
|
|
Operate |
|
|
Check that DRAIN STOPPER (5) makes a good seal |
|
|
and retains water in SINK. If DRAIN STOPPER (5) |
|
|
does not seal properly, please refer to Troubleshooting |
|
|
section in these instructions. | 5 | 3 |
| ||
Release |
| |
|
|
connections and "P" trap for leaks. | Tighten |
if necessary. |
|
| WASTE |
| OUTLET |
2 | 2 |
“P” TRAP |
10 SERVICE
To change direction of handle rotation, proceed as follows:
Turn VALVE in OFF position.
If spout drips, operate HANDLES (1) several times from OFF to ON | 1 |
position. Do not |
|
To change direction of handle | 2 |
rotation, proceed as follows: | 4 |
|
Turn VALVE to OFF position.
Loosen HANDLE SCREW (2), and pull HANDLE (1) off ADAPTOR (3).
Remove ADAPTOR SCREW (4).
Pull ADAPTOR (3) off VALVE STEM (5) and turn 90˚ in a way that flat in ADAPTOR (3) catches a different flat in on VALVE STEM (5).
Reinstall ADAPTER SCREW (3), HANDLE (1) and HANDLE SCREW (2).
AERATOR (6) may accumulate dirt causing distorted and reduced water flow. Remove AERATOR (6) and rinse clean.
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90˚.
90˚
3
FLAT
5
6
11 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M968806 REV 1 . 3
4
