American Standard 6060LC Lifetime Corner, Whirlpools By American Standard, High Gloss Acrylic

LIFETIME™ CORNER

WHIRLPOOLS BY AMERICAN STANDARD

HIGH GLOSS ACRYLIC

OUTLINE OF

CUTOUT

15"

(381mm)

CUT OUT IN FLOOR

FOR DRAIN

76-3/4"
(1949mm)
	54-1/2"
	(1384mm)
	65-3/8"
	(1661mm)
10"
(254mm)	3"
	(76mm)
	7"
	(178mm)
	17-3/4"
13-3/4"	(451mm)
(349mm)
7"
(178mm)
65-3/8"
(1661mm)

	C/L OF
19-1/2"(C)	OVERFLOW
(495mm)	21-1/2"(H)
18"(A)	(546mm)
(457mm)
	8"
	(203mm)

DIMENSIONS OF FIXTURES ARE NOMINAL AND MAY VARY WITHIN THE RANGE

OF TOLERANCES ESTABLISHED BY ANSI STANDARDS Z124.1 AND A112.19.7.

GENERAL SPECIFICATIONS FOR 6060L WHIRLPOOL

INSTALLED SIZE		76-3/4 x 65-3/8 x 21-1/2 In. (1949 x 1661 x 546mm)
WEIGHT							108 Lbs. (49 Kg.)
WEIGHT w/WATER							824 Lbs. (374 Kg.)
GAL. TO OVERFLOW								86 Gal. (325 L)
WHIRLPOOL MIN. OPERATING VOL.								71 Gal. (269 L)
BATHING WELL AT SUMP			48 x 26-1/2 In. (1219 x 673mm)
BATHING WELL AT RIM					63 x 50 In. (1600 x 1270mm)
WATER DEPTH TO OVERFLOW								15 In. (381mm)
FLOOR LOADING				24 Lbs./Sq.Ft. (116 Kgs./Sq.m)
(PROJECTED AREA)
	WHIRLPOOL ELECTRICAL SPECIFICATIONS
PUMP						2.1 HP, 14.4 AMPS,120V.
E-Z INSTALL WHIRLPOOL HEATER							12.0 AMPS,120V.

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUPPORT OF BATH BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.

■REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION. OPTIONAL 2-WALL TILING BEAD KIT No.TILE-BEAD MUST BE ORDERED SEPARATELY.

▲CUTOUT TEMPLATE PROVIDED IN SHIPPING BOX. MAY BE REQUESTED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.

FITTINGS NOT INCLUDED, MUST BE ORDERED SEPARATELY.

IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM PIPING, DRAIN OVERFLOW, AND APRON INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1 These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.

HD-2

© 2007 American Standard Inc. Revised 7/07