American Standard 7005.201 Test Installed Fitting, Check Drain Connections, Service

10 TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).	4
Operate both HANDLES (1) to flush water lines thoroughly.	1

Replace AERATOR (3).

1

CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshooting section in these instructions.

Release POP-UP KNOB (4) down and check all drain	3
	5
connections and "P" trap for leaks. Tighten
if necessary.

WASTE

OUTLET

2

2 “P” TRAP

11 SERVICE

To change direction of handle:

Turn valve to OFF position
Remove SET SCREW (6) with 5/64" Hex Wrench.
Pull HANDLE (1) “UP” firmly to release from ADAPTER (2).	1

Pull HANDLE BASE (7) off of CARTRIDGE (8).

Remove ADAPTER SCREW (3) from ADAPTOR (2). Pull off ADAPTER (2).

Remove SPRING CLIP (4). Lift STOP WASHER (5), turn 90˚ and replace. Replace SPRING CLIP (4).

Replace ADAPTER (2) and ADAPTER SCREW (3).

Find correct position of HANDLE ASSEMBLY (1) by adjusting male teeth on ADAPTER (2) to female teeth in HANDLE ASSEMBLY (1).

Push HANDLE (1) down onto ADAPTER (4) until it snaps into place.

6

	90˚	7
		3
		5
4		2
		8

12 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M968635 REV. 1. 1

4