1 | AFTER THE CUTOUT IS DRAWN... | |
|
| |
Drill a clearance hole | Perimeter | |
of sink | ||
inside the cutout line |
| |
as marked on the |
| |
countertop. |
| |
|
| Cutout |
5 Remove sink and apply a masking tape outline 1/8" outside traced outline as a guide for application of silicone sealant.
|
| Cutout |
Masking | 1/8" | Sink |
tape | outline | |
outline |
|
|
2 | Cut opening on cut line |
|
|
Perimeter |
| ||
inside the perimeter of | of sink |
| |
| sink. |
|
|
|
|
|
| Note - Formica counter- |
|
| top installation only is |
|
| illustrated. Contact your |
|
| countertop distributor for | Cutout |
| the best method of cut- | |
| ting other materials such |
|
| as marble, hard syn- |
|
| thetics, etc. |
|
3 | Mount the faucet and |
|
drain assembly on the |
| |
| sink or countertop |
|
| following the |
|
| manufacturer's |
|
| instructions. |
|
Before applying the sealant,
4 place the sink temporarily into the cutout. Check for alignment and clearance, then trace around the outside edge of the sink as a guide for installation location and application of sealant.
AMERICAST® LIMITED LIFETIME WARRANTY
If an
This warranty applies only to the original purchaser and installation of these products.
This warranty does not apply to whirlpool components or to faucets, drains, mounting rims, grab bars or other accessories. If manufactured or supplied by American- Standard, such whirlpool components and accessories are covered under separate limited warranties.
This warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser of this product should check with a local building or plumbing contractor to assure local code compliance before installation.
This warranty shall be void if the Americast® brand product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or other damage; if it was not installed in accordance with American- Standard’s instructions; or if it was modified in a manner inconsistent with the product as shipped by
Standard be responsible for any other incidental or consequential damages attributable to a product defect or to the repair or exchange of a defective product, all of which are expressly excluded from this warranty. (Some states or provinces do not allow the exclusion or limitation of implied warranties, so this exclusion may not apply to you.)
This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to province, in which case this warranty does not affect such statutory rights.
For service under these warranties, it is suggested that a claim be made through the contractor or dealer from or through whom the product was purchased, or that a service request (including a description of the product model and of the defect) be sent to the following address:
6 Apply a generous portion of silicone sealant inside line traced on countertop. Carefully lower sink into place and press down firmly. Use guidelines for proper positioning. Using water to dampen your finger, remove excess sealant for a smooth even line. Apply additional sealant if necessary to provide a uniform bead from the rim of sink to the masking tape line as shown. Carefully remove tape. Dampen finger and run it slightly over the sealant to remove any high spots. Use mineral spirits to remove excess silicone from countertop and sink.
Sink
Masking
Tape
NOTE: Silicone must be removed within 10 minutes of application or a permanent residue may remain on the surfaces.
7 Connect supply lines to faucet finger tight, and carefully bend to engage with the supply stops. Tighten connections to faucet for secure seal.
8 | Connect drain assembly |
|
|
hand tight to check align- |
|
| |
| ment. It may be necessary |
|
|
| to cut off part of the tailpiece |
| B |
| (area "A") or part of the | A | |
|
| ||
| horizontal leg of the trap |
|
|
| (area "B"). |
|
|
| Secure joint for watertight |
|
|
| assembly. |
|
|
| Trap |
| Trap |
|
|
| |
| Single Bowl |
| Double Bowl |
CARE AND CLEANING...
For all porcelain enamel surfaces, regular, gentle care is best. The recommended way to preserve the finish, avoid scratches, and clean porcelain enamel fixtures is to rinse them with detergent and water. Generally, any of the light duty liquid dishwashing detergents, such as Palmolive or Dawn, work well. In areas where the water is hard,
a heavy duty liquid laundry detergent such as liquid Tide will work better.
Product names listed herein are trademarks of American Standard Inc.unless otherwise noted. Palmolive® is a registered trademark of
Tide® and Dawn® are registered trademarks of Procter and Gamble.
In the United States:
American Standard Inc.
P.O. Box 6820
Piscataway, New Jersey 08855
Attention: Director of Consumer Affairs
For residents of the United States, warranty information may also be obtained by calling the following toll free number: (800)
In Canada: | In Mexico: |
American Standard | Customer Service Manager |
2480 Stanfield Rd. | Ideal Standard, S.A. de C.V. |
Mississauga, Ontario | Via Morelos #330 |
Canada L4Y 1S2 | Col. Santa Clara |
Toll Free: (800) | Ecatepec 55540 Edo. Mexico |
www.AmericanStandard.ca | www.AmericanStandard.com.mx |
7 9 0 7 1 5 - 1 0 0 R e v . S | 2 | © A M E R I C A N S T A N D A R D I N C . 2 0 0 4 |