13 TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3). First loosen aerator set screw with
HEX WRENCH (6) supplied. Pull out AERATOR (3) with
AERATOR KEY (7).
Operate both HANDLES (1) to flush water | 1 |
lines thoroughly.
Replace AERATOR (3) and tighten set screw.
5
14 CHECK DRAIN CONNECTIONS
Operate
Release
if necessary.
WASTE
OUTLET
6
1
AERATOR
SET
SCREW
3
7
4
2
COLD
“P” TRAP
| HOT | 2 | ||
|
| |||
15 SERVICE | 16 | SPOUT CAN BE FIXED OR SWIVEL. | ||
CONVERT TO A FIXED SPOUT IF DESIRED. | ||||
To change direction of handle | To change from swivel to fixed spout, proceed as follows: | |||
| Remove PLUG BUTTON (1) from back of spout. VIEW “A” | |||
rotation, proceed as follows: |
| |||
Turn valve to OFF position. |
| Remove SET SCREW (2) using screwdriver. | ||
| Install FIXING SET SCREW (3) using Hex Wrench supplied. | |||
Thread |
| |||
| Align SPOUT (4) and tighten SET SCREW (3) to secure SPOUT (4). | |||
HANDLE BASE (1) to remove |
| |||
| Replace PLUG BUTTON (1). | |||
HANDLE ASSEMBLY (2) from |
| |||
|
|
| ||
ESCUTCHEON BASE (3). |
|
|
| |
Use a flat blade screw driver | 2 |
|
| |
to remove SPRING CLIP (4). | 1 |
|
| |
Lift STOP WASHER (5), turn 90˚ |
|
| 1 | |
and replace. |
|
| ||
VIEW "A" | 3 | |||
Replace SPRING CLIP (4). | ||||
Reinstall HANDLE ASSEMBLY (2). |
|
| 4 |
If spout drips, operate handles | 90˚ |
| 2 |
several times from OFF to ON | 5 |
|
|
position. Do not force - handles | 4 | VIEW "A" | |
turn only 90˚. | 3 |
| |
| VALVE | 1 | |
|
|
|
17 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M968640 REV . 1 . 1
5