1 | INSTALL FAUCET |
|
|
|
|
| |||
| CAUTION |
| ||
|
| Turn off hot and cold water supplies before beginning. | ||
|
|
|
|
|
Apply a bead of PUTTY along the edge of the underside of the BODY. Insert faucet SHANKS through holes of SINK.
Place faucet as far forward as possible.
Assemble and tighten MOUNTING NUTS from underside of SINK.
Connect the HOT water supply to the left SHANK and the COLD water supply to the right SHANK using sealant, appropriate connectors, and COUPLING NUTS.
Insert LIFT ROD through hole in BODY.
SINK
LIFT
ROD
BODY
PUTTY
SHANK
MOUNTING
NUT
COLD
HOT
COUPLING NUT
2 INSTALL POP-UP DRAIN
Thread TAILPIECE into DRAIN BODY and tighten securely.
STOPPER |
| Drop STOPPER into DRAIN BODY. Operate LIFT ROD. | |
| |||
|
|
| Adjust STOPPER movement by repositioning EXTENSION |
|
|
| |
|
|
| on LIFT ROD. |
Thread LOCKNUT fully onto DRAIN BODY. Drop WASHER and GASKET onto DRAIN BODY.
Remove CLIP from PIVOT ROD. Assembly PIVOT ROD to DRAIN BODY with BUSHING.
Apply a bead of putty to underside of FLANGE. | SINK |
|
Insert DRAIN BODY from below through SINK
hole with the PIVOT ROD pointed toward the LIFT ROD.
FLANGE
PUTTY
CLIP
GASKET
THUMBSCREW
DRAIN BODY
LIFT ROD
EXTENSION
ROD
Thread FLANGE fully onto DRAIN BODY. Tighten |
|
LOCKNUT firmly, keeping the PIVOT ROD pointed | LOCKNUT |
toward the LIFT ROD. |
Slide EXTENSION onto LIFT ROD and insert PIVOT ROD through the second or third hole. Secure with CLIP. EXTENSION may need to be bent to suit installation.
Move PIVOT ROD fully downward. Tighten THUMBSCREW.
WASHER |
| TAILPIECE |
|
| |
| PIVOT | TRAP |
| ROD | |
|
|
BUSHING | EXTENSION | |
ROD | ||
| ||
TAILPIECE |
| |
INSERT | CLIP | |
TAILPIECE | PIVOT | |
ROD | ||
| ||
TRAP |
|
3 TEST INSTALLED FAUCET
Remove AERATOR.
Turn HANDLES to OFF position.
Slowly turn on water supplies and check all connections for leaks.
4 SERVICE
AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean.
HOT LINE FOR HELP
For
1 (800)
Weekdays 8:00 a.m. to 7:00 p.m. Eastern Time Saturdays 8:00 a.m. to 4:00 p.m. Eastern Time
IN CANADA
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c . © A m e r i c a n S t a n d a r d I n c . 1 9 9 9
Operate both HANDLES to flush water lines thoroughly.
Operate LIFT ROD and check DRAIN connections for leaks.
Turn HANDLES to OFF position and replace AERATOR.
ALIGN HANDLES
INDEX
BUTTON
Turn HANDLES to their off position.
HANDLE
SCREW
Remove INDEX BUTTON and HANDLE
SCREW.
LEVER
Remove HANDLE and replace onHANDLE VALVE STEM in desired position.
Replace HANDLE SCREW and INDEX
BUTTON.
VALVE
STEM
M 9 6 8 1 2 0