2 MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning. |
| |
Connect FLEXIBLE SUPPLIES (1, 2) directly |
| |
to wall supplies. Connection on fitting |
| |
supplies are 3/8" compression. Connect |
| |
left supply (Marked with a Red Stripe) to Hot |
| |
and right supply (Marked with Blue Stripe) to | 2 | |
Cold wall supply. Use adjustable wrench to | ||
| ||
tighten connections. Do not over tighten. | 1 | |
| ||
Faucet supplies are 21" long from faucet base. |
| |
Note: If additional supply length is | COLD | |
| ||
required, installer must purchase | HOT | |
additional parts separately. |
Important: If SUPPLY HOSES (1, 2) are too long, loop as illustrated to avoid kinking.
3 INSTALL WEIGHTS
With HAND SPRAY (1) seated in FAUCET (2), install WEIGHTS (4) onto HOSE (3) using two SCREWS (5). Locate the WEIGHTS (4) two feet (2') from the underside of the sink deck.
Tighten SCREWS (5) firmly.
2
1
24"
4 TEST INSTALLED FAUCET
Move HANDLE (1) down into "off" position.
Turn on water supplies. Check connections for leaks.
(See Section 5)
6 8
With HANDLE (1) down in "off" position, pull HAND SPRAY (2) from FAUCET (5) and disconnect HAND SPRAY (2). Be careful not to lose WASHER (7). Pull HOSE (3) (HOSE should pull approximately 2 feet) and direct open HOSE END (4) into sink.
3
4 5
2
7
4
| 1 | Operate handle up and down, in COLD and HOT positions, | |
|
| to flush water lines thoroughly. | |
|
| Place WASHER (7) into HOSE END (4) and | |
|
| connect HAND SPRAY (2) to HOSE END (4). | |
3 |
| Place HAND SPRAY (2) back into faucet. | |
5 | Check HAND SPRAY (2) operation: | ||
| |||
|
| With faucet on push BUTTON (6) for a broad cleansing | |
|
| spray. BUTTON (6) will lock into this position. | |
|
| To unlock BUTTON (6), rotate BUTTON (6) left or right | |
|
| using the TAB (8). Faucet will return to standard spray. |
M968473 REV 1. 8