![1 INSTALL VALVE TRIM](/images/new-backgrounds/200700/2007003x1.webp)
1 INSTALL VALVE TRIM
Figure 1. Remove plaster guard from valve. Push CAP (1) over VALVE CARTRIDGE (2) until seated against stop.
Figure 2. Make sure
(3)onto CAP (1) and attach with LONG SCREWS (4). Mount ESCUTCHEON SUPPORT (5) to ESCUTCHEON HOLDER (3) with 4 SHORT SCREWS (6).
Figure 3. Install ESCUTCHEON (7) onto CAP (1) and push flush against finished wall. Escutcheon (7) will snap fit onto ESCUTCHEON SUPPORT (5).
1
| 3 |
8 | 5 |
Figure 2. | 4 |
6
PLSTER | 1 |
GUARD | |
Figure 1. | 2 |
| |
| 7 |
5 | 1 |
Figure 3. |
|
2 | INSTALL DIVERTER KNOB, TUB SPOUT, SHOWER HEAD, |
|
|
|
SHOWER ARM WITH FLANGE |
| 2 |
| |
| Remove pipe cap and plug from shower and tub |
|
| SHR. |
| rough piping. |
|
| ELBOW |
|
|
|
| |
| Install TUB SPOUT (1) onto tub nipple. |
| 3 | PIPE |
| 4 | PLUG | ||
| CAUTION: Protect finish on TUB SPOUT when |
|
| |
|
|
|
|
installing.
Install SHOWER ESCUTCHEON (2) onto SHOWER ARM (3). Apply sealant or Teflon tape to threads on both ends of SHOWER ARM (3) and thread longer leg of SHOWER ARM (3) into shower elbow.
Thread SHOWER HEAD (4) onto SHOWER ARM (3).
CAUTION: Protect finish on SHOWER HEAD and
ARM when installing.
Install HANDLE (5) onto CARTRIDGE STEM (6). Tighten
SET SCREW (7) with HEX WRENCH (8) supplied.
5
7 | 6 | |
8 | ||
TUB FILLER |
NIPPLE
PIPE
CAP
1" MIN.
1
M968628 REV.1.3