Ampeg PF-115HE, PF-210HE Rear Panel Connector Plate, System Block Diagrams, 1/4" TS Full Range Input / Output Jacks:, High Frequency Horn Level Switch:, PF-115HE, PF-210HE

PF-115HE / PF-210HE Speaker Cabinet

Rear Panel Connector Plate

PF-xxxHE

IMPEDANCE: 8 OHMS	HIGH
POWER: 400W RMS	FREQUENCY
	ATTENUATOR	FULL RANGE
	OFF –60	INPUTS

21

1.1/4" TS Full Range Input / Output Jacks: The jackplate features two 1/4" jacks wired in parallel, allowing easy daisy-chaining from one speaker to another. Each of the jacks may be used as an input or a through connection.

Connect the speaker-level output of your amplifier to the cabinet’s input jack using a good quality (non-shielded) speaker cable (included). Never use (shielded) instrument cable to connect speakers to an amplifier.

You can utilize the unused jack as an output/through jack to connect a second 8 ohm speaker cabinet in parallel. This will present a total load of 4 ohms to the amplifier.

2.High Frequency Horn Level Switch: The three-position HF Horn switch allows for:

•Full high frequency output (0 setting)

•High frequencies reduced by 6 dB (–6 setting)

•Horn shutoff (off setting)

System Block Diagrams

COMPRESSION		15" EMINENCE	COMPRESSION		10" EMINENCE
DRIVER		8 OHM SPEAKER	DRIVER		16 OHM SPEAKERS
– +
		– +
	CROSS	TWO		CROSS	TWO
				OVER
	OVER				PARALLEL
		PARALLEL
					JACKS
		JACKS

PF-115HE PF-210HE

3