Ampeg SVT-8 Some Suggested Settings, Rack Mounting

SVT-8 PRO Bass Amplifier

Some Suggested Settings

Ampeg Rock:

Jazz:

Country:

Funk:

Funk Popping:

	GAIN	ULTRA LOW	ULTRA HIGH		BASS	MIDRANGE		FREQUENCY	TREBLE		DRIVE	POWER
			/54								PULL ON
			/54
			BRIGHT
		PEAK	/54								ON
0	10	1 2 3 4 5	/54	0	10	0	10	1 2 3 4 5	0	10	POWER REDUCTION
		1 2 3 4 5						1 2 3 4 5			POWER REDUCTION
	ADJUST UNTIL PEAK LED FLASHES										PULL - SET AS NEEDED
	GAIN	ULTRA LOW	ULTRA HIGH		BASS	MIDRANGE		FREQUENCY	TREBLE		DRIVE	POWER
			).								PULL ON
			).
			BRIGHT
		PEAK	/54								ON
0	10	1 2 3 4 5	/54	0	10	0	10	1 2 3 4 5	0	10	POWER REDUCTION
		1 2 3 4 5						1 2 3 4 5			POWER REDUCTION
	ADJUST UNTIL PEAK LED FLASHES
	GAIN	ULTRA LOW	ULTRA HIGH		BASS	MIDRANGE		FREQUENCY	TREBLE		DRIVE	POWER
			/54								PULL ON
			/54
			BRIGHT
		PEAK	/54								ON
0	10	1 2 3 4 5	/54	0	10	0	10	1 2 3 4 5	0	10	POWER REDUCTION
		1 2 3 4 5						1 2 3 4 5			POWER REDUCTION
	ADJUST UNTIL PEAK LED FLASHES
	GAIN	ULTRA LOW	ULTRA HIGH		BASS	MIDRANGE		FREQUENCY	TREBLE		DRIVE	POWER
			).								PULL ON
			).
			BRIGHT
		PEAK	/54								ON
0	10	1 2 3 4 5	/54	0	10	0	10	1 2 3 4 5	0	10	POWER REDUCTION
		1 2 3 4 5						1 2 3 4 5			POWER REDUCTION
	ADJUST UNTIL PEAK LED FLASHES
	GAIN	ULTRA LOW	ULTRA HIGH		BASS	MIDRANGE		FREQUENCY	TREBLE		DRIVE	POWER
			).								PULL ON
			).
			BRIGHT
		PEAK	/54								ON
0	10	1 2 3 4 5	/54	0	10	0	10	1 2 3 4 5	0	10	POWER REDUCTION
		1 2 3 4 5						1 2 3 4 5			POWER REDUCTION

ADJUST UNTIL PEAK LED FLASHES

Rack Mounting

When mounting the SVT-8 PRO into a rack, the four bottom feet should be removed to maintain the two rack space height of the ampli- fier. Be sure to keep the feet and their attachment bolts for future use. If the feet are reinstalled, never use screws which will protrude farther into the amplifier than the original hardware!

The rack must be a high quality enclosure capable of securely supporting the weight of the amplifier. Tighten the mounting screws securely through the amplifier’s face plate, into the rack rails. Check the rack and mounting screws occasionally to ensure a continually safe and secure installation. Additional rack ears are provided on the rear of the amplifier for connection to an additional support brack- et. It is highly recommended that this additional support be used when rack mounting the amplifier.