AMS ALPHA 215 , ALPHA Big Dot Data Receiver Setup (continued)

ALPHA™ Wireless Data Receiver Installation Manual

ALPHA Big Dot® Data Receiver Setup (continued)

Step 4: Get the Jumper from your Data Receiver Kit. The

Jumper (right) is a small dark piece of plastic.

When installing the Jumper, be careful not to drop it inside the ALPHA Big Dot®

case. If the Jumper falls inside, service may be required to remove it.

Step 5: Locate the Two-Prong Receptacle that is below the EPROM. If there already is a

jumper over these two prongs, then go to Step 6. Otherwise, place the Jumper

bottom over the two prongs. Then push down until the Jumper is secure:

Figure 8: Where to install the Jumper.

Jumper top

Jumper bottom

STOP

Place the

Jumper

over these

two prongs.

Contents

Main ALPHA Wireless Data Receiver Installation Manual plus Installation Instructions Whats included in the Data Receiver Kit? ALPHA 215 Data Receiver Setup ALPHA 215 Data Receiver Setup (continued) ALPHA 215 News Service Setup (continued) For Flush Wall Mounts For Ceiling Hanging, Countertop, and Wall Mounting Brackets: ALPHA Big Dot Data Receiver Setup ALPHA Big Dot Data Receiver Setup (continued) ALPHA Big Dot Data Receiver Setup (continued) For Ceiling Hanging, Countertop, and Wall Mounting Brackets: left ALPHA 4000 Series Data Receiver Setup ALPHA 4000 Series not leftmost Page ALPHA 7000 Series Data Receiver Setup ALPHA 7000 Series not leftmost Page ALPHA 300 Series Data Receiver Setup