GENERAL SAFETY INFORMATION
WARNING: REVIEW ALL GENERAL SAFETY INFORMATION PRIOR TO INSTALLATION.
READ CAREFULLY THE PRODUCT INSTALLATION, OPERATING
AND MAINTENANCE INSTRUCTIONS. FAILURE TO FoLLOW THE INSTRUCTIONS AND WARNINGS IN THE MANUAL MAY RESULT IN SERIOUS OR FATAL INJURY AND/OR PROPERTY DAMAGE, AND WILL VOID THE PRODUCT WARRANTY. THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED PROFESSIONAL. FOLLOW ALL APPLICABLE LOCAL AND STATE CODES AND REGULATIONS, IN THE ABSENCE OF SUCH CODES, FOLLOW THE CURRENT EDITIONS OF THE NATIONAL PLUMBING CODE AND NATIONAL ELECTRIC CODE, AS APPLICABLE.
This product is used in conjunction with a system containing a tank 
under pressure, which may over time corrode, weaken and burst or explode, causing serious or fatal personal injury, leaking or flooding and/or property
damage. To minimize risk, a licensed professional must install and periodically inspect and service the product and system. A drip pan connected to an adequate drain must be installed if leaking or flooding could cause property damage. Do not locate system in an area where leaking could cause property damage.
EXPLOSION OR RUPTURE HAZARD. A relief valve must be
installed to prevent system pressure in excess of local code requirement or maximum working pressure designated in the Product Manual, whichever is less. Do not expose system to freezing temperatures or temperatures in excess of 120 degrees. Failure to properly size the system or follow instructions in the Manual may result in excessive strain on the system and may lead to product failure, leakage, flooding and/ or property damage.
This control is capable of running pumps to pressures that may
exceed the limitations of system components. Never set the operating pressure higher than that of the safe system capacity.
This control can be adjusted to a narrow pressure differential. This 
can cause the pump to cycle rapidly with an improperly sized tank, leading to pump damage. This may require a larger pressure tank than is normally used.
ELECTROCUTION HAZARD. Must be installed by qualified professional. First disconnect all electrical power before attempting service. For your safety, the information in this Manual must be followed to minimize the
risk of electric shock, property damage or personal injury.
A water test must be taken before installation of any water treatment
equipment. The water quality can significantly influence the life of your system. You should test for corrosive elements, acidity, total solids and other relevant contaminants, including chlorine and treat your water appropriately to insure satisfactory performance and prevent premature failure.
Use only 
as required by state and federal codes.
6
