Mounting the Magnetic Post Housing on a Mio Modero DMS
If the Mio Modero does not already have the magnetic post housing attached, follow these steps. The Mio Modero DMS will not stay in the conduit box without the magnetic post housing. Only the new conduit box can be used with the magnetic posts.
To avoid any damage to the electronic component, installation must be performed in an ESD safe environment.
1.If in the wall, remove the Mio Modero DMS from the conduit box. Place a flathead screwdriver between the tab of the conduit box and the notch of the Mio Modero DMS and pop the two apart. Pull the bottom of the unit out (pivoting on the top clip) until it seems to bind against the shielding; while keeping the unit at this angle, pull the top of the unit away from the top clip.
2.Place the Mio Modero DMS unit face down on a flat surface.
3.Unscrew the 4 points illustrated in FIG. 3.
4 screws
FIG. 3 Rear View of Mio Modero DMS
Screw points for magnetic mounting.
(Side view)
FIG. 5 Rear and side view of magnetic housing
7.Insert the provided cardboard paint shield into the conduit box if the Mio Modero DMS will not be installed at this time.
4.Screw 4 standoffs provided with the conduit box kit into the holes from the previous step.
5.Place the hex post over the hole illustrated in FIG. 4 and fasten it down with the screw on the bottom side of the board.
4
standoffs
| Hex Post |
|
|
| and |
|
|
| Screw |
|
|
| Magnetic Post Housing |
|
|
FIG. 4 4 Standoffs and Hex Post locations |
|
| |
6. | Place and fasten the magnetic housing onto the standoffs as illustrated in |
|
|
| FIG. 5. Note the orientation of the cutout on the magnetic housing in |
|
|
| relation to the Mio Modero DMS board, it should not be mounted in any |
|
|
| other fashion. Use either the 4 screws removed in step #3 or the 4 |
|
|
| screws provided with the kit (for those that already lost the other 4 |
|
|
| screws). |
|
|
| For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). |
| REV: A |
|
| ||
|
|
| |
| ©2006 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX. |
|
|
| AMX reserves the right to alter specifications without notice at any time. |
|
|
| 3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com |
|
|
