AMX specifications Specifications, RDM-3EM and RDM-6EM UL and C-Ul Ratings, Installation Sheet

Installation Sheet

RDM-3EM and RDM-6EMEnergy Management Modules

The RDM-3EM (FG606-81) and RDM-6EM (FG606-80) are 3 and 6 channel switching energy management modules. They are designed for use with the RDA series of enclosures in an AMX Lighting™ system.

For more detailed installation and operating instructions, refer to the Radia Lighting Control System Instruction Manual, available on-line at www.amx.com.

The RDM-3EM and RDM-6EM are designed with the most advanced latching energy management relays to support heavy duty commercial applications, building automation, and loadside management. Equipped with on-board module microprocessors, both support relay control and sequencing. Features include:

•User selectable delays in sequencing mode to minimize inrush current and stress on the electrical distribution system.

•Selectable strapping facilitates multiple relays on one Radia control channel for large area control.

•Manual on/off override on each relay independent of control system.

•Relays retain their state during power and control system outages.

•Visual Status Indicators on each relay.

•Latching relays do not consume any control current, except when they change state, eliminating the need for additional Radia power supplies.

	Mounting
	points
1
2
		Relays
3
	(1-6)
4

Control

Port

Strapping

Jumpers

(JP3 - JP4)

FIG. 2 RDM-3EM

			Mounting
			points
	1
					Relays
2
				(1-3)
		3

Sequencing

Delay Jumpers

(JP1 and JP2)

Mounting points

5

6

Control
Port	Sequencing
Strapping
	Delay Jumpers
Jumpers
(JP3 - JP7)	(JP1 and JP2)

Mounting points

FIG. 1 RDM-6EM

Specifications

•Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)

•Non-phase dependant

•Use wires rated at 75°C (167°F)

•Torque terminals to 4.4 in lbs.

•Wire size: 26 AWG to 10 AWG

•Wire stripping length: 0.28" (7 mm)

•Weight: 15 oz. (RDM-3EM) and 1.5 lbs. (RDM-6EM)

RDM-3EM and RDM-6EM UL and C-Ul Ratings

•General purpose: 120, 240, 277, and 347* VAC, 20 A

•UL/CUL916 Energy Management Systems.

•UL/CUL508 Industrial Control Systems.

Suggested Switched Loads

•Incandescent

•Fluorescent

•Transformer

•Low voltage

•General purpose

Caution: Pre-Installation Notes

•All Class 1 wiring must be connected to proper terminals.

•All control wiring must be connected to proper terminals.

•Disconnect power while installing or connecting the unit.

•Keep top and bottom air vents clear at all times.

•Test loads for shorts before connecting.

•Use low voltage wires with a 300 volt rating or greater.

•Use field installed copper conductors.

•All electrical ratings are for continuous duty.

•For indoor use only.

Included Accessories

•4 mounting screws

•Control wiring harness

*Agency approval pending