Model AGR+ With Battery Use
Models AGRC/AGRV/AGR+ can be used with either the cord pack or the battery.
READ THE FOLLOWING BEFORE CHARGING THIS CLIPPER
1. Remove the charger from the carton and plug into an AC outlet as identified on charger unit and on carton.
2. Place the clipper in the form fitting pocket in the charger base (Diagram B). Note that the battery pack is fitted with a slot to
align properly with the charger. Once the battery and charger |
| |
are aligned, press the battery pack firmly into the charger until |
| |
it rests at the bottom of the pocket. You may hear a click as |
| |
the charging contacts engage this is normal. The battery pack |
| |
may be charged while on the clipper, or separately. Push the |
| |
battery release button (Diagram C) on the clipper, and pull | Diagram B | |
straight out to remove the battery. NOTE: The battery pack is | ||
designed to run the clipper for about one hour. A clean, sharp, |
| |
| ||
shop may want an additional battery pack, so one pack is |
| |
charging while the other is running the clipper. |
| |
3. Before initial use battery pack must be charged for a | Battery | |
minimum of one hour. | Release | |
4. The charger base has two indicator lights. Below is a | ||
| ||
description of the Sensacharge light sequences (Diagram D). | Tongue | |
NOTE: The continuous red light may turn on at the end of the |
| |
fast charge cycle for a NiMH battery pack. This is a normal |
| |
condition and the battery pack is still ready for use. This |
| |
precaution is to prevent multiple fast charge cycles while the |
| |
battery is hot. The red light will go out after a few minutes. |
| |
Continuous Green Light (Fast Charge): Charger will fully |
| |
charge battery pack in less than one hour. |
| |
Rapid Green Blinking Light (Charging Complete): Battery pack | Diagram C | |
is fully charged. |
|
Long Green Blinking Light (Refresh): Charger is draining battery pack in preparation for fast charge. Please reference the section “Use of the Refresh Feature” on page 6 for an explanation.
Short Green Blinking Light: |
|
a) With continuous red light (Charge Standby): Battery pack |
|
is trickle charging because it is either too hot or too cold to |
|
accept a fast charge. Fast charging will occur once battery | Diagram D |
pack temperature moderates. |
|
b)Without Red Light (Charge Preparation): Battery pack is undergoing trickle charge, because it has been drained excessively during use.
5.The clipper can be left in the charger base for an indefinite period of time. The charger will supply only what is needed and will not damage the battery due to overcharge.
4
