6
OPERATION
To generate smoke, press the button on the front of the M-1 Mobile Fogger’s
handle.
There are two operation modes that can be selected for the M-1.
1. Operation mode 1. Allows the fog machine to fog as long as the handle’s
button or the remote control’s button is pressed down. To stop fogging, stop
pressing the button.
2. Operation mode 2. Works on a press once to start and press again to stop
basis. In this mode, start fogging by pressing the button. The M-1 will fog
continuously until the button is pressed a second time.
Use the small switch on the right side of the M-1. The switch is inside the case and
is adjusted through the small hole on the side of the case.
To select operation mode 1. Slide the switch towards the back of the M-1
(towards the cap on the liquid tank).
To select operation mode 2. Slide the switch towards the front of the M-1
(towards the nozzle).
When an optional remote is connected, please see the detailed instructions for
their operation below.
The machine will fog until the battery charge runs down or the M-1 runs out of fog
liquid. When the M-1 is connected to the optional power adaptor, carefully monitor
the level of the fog liquid to make sure the machine does not run out of liquid.
Operating continuously, the machine will run out of liquid in approximately 50
minutes.
A full battery charge will power the M-1 for a period of 10-12 minutes before
needing to be recharged. When using the battery, the charge will run down several
times before the fluid needs to be refilled.
Note: There is no warm-up time with the M-1 Mobile Fogger. Unlike most other
fog machines, you do not have to wait for the heater to warm-up before
fogging.