Antec Mini P180 White Connecting the eSATA Port, Connecting the Audio Ports AC’97 and HDA

Note: Please check your motherboard manual for your USB header pin layout and make sure it matches the table below.

			Motherboard Pin Layout
1	2
		Pin	Signal Names	Pin	Signal Names
		1	USB Power 1	2	USB Power 2
		3	Negative Signal 1	4	Negative Signal 2
		5	Positive Signal 1	6	Positive Signal 2
		7	Ground 1	8	Ground 2
9	10	9	Key (No Connection)	10	Empty Pin

Connecting the eSATA Port

This case comes with an eSATA port in the front of the case to connect to your external SATA devices. You will find a SATA connector on a cable attached to the front eSATA ports. Connect it to a SATA connector on your motherboard.

Connecting the Audio Ports (AC’97 and HDA)

There is an Intel standard 10-pin AC’97 connector and an Intel 10-pin HDA (High Definition Audio) connector, you can connect either of them to your motherboard depending on the specification of the motherboard. See instruction below:

106 4 2

9 7 5 3 1

Pin Assignment for Audio Ports (HDA and AC’97)

Pin	Signal Names	Pin	Signal Names
	(HDA)		(AC’97)
1	MIC2 L	1	MIC In
2	AGND	2	GND
3	MIC2 R	3	MIC Power
4	AVCC	4	NC
5	FRO-R	5	Line Out (R)
6	MIC2_JD	6	Line Out (R)
7	F_IO_SEN	7	NC
8	Key (no pin)	8	Key (no pin)
9	FRO-L	9	Line Out (L)
10	LINE2_JD	10	Line Out (L)

Note: Please check your motherboard manual for your audio header pin layout and make sure it matches the table. Even if your system supports both audio standards, you may only connect one connector, not both.

Installing the Drives

With the front bezel facing you, swing the front door out. It can swing 270 degrees so the door will be parallel with the side of the case. You can see one 5.25” external drive bay at the top and two 5.25” drive bays at the bottom of the

3