![](/images/backgrounds/20632/20632-8666x1.png)
7.SETUP MENU continued …
7.4.9 TRIGGERS / IR /
When a trigger output on the AVM 30 is connected to the trigger input of another component, such as a power amplifier or video projector, the AVM 30 can turn the component on or off according to the trigger’s Setup. For components that do not use triggers, a triggerable power bar may work (see your dealer).
•Trigger1 and Trigger2: Provide standard trigger output of 12 volts with up to 50 mA of current, suitable for typical source components and most amplifiers.
•Trigger3: Provides an output of 12 volts with up to 200 mA of current, suitable for triggers on motorized projection equipment and very high power amplifiers.
There is a quarter of a second delay between each trigger to minimize momentary line voltage drops caused by switching on too many devices at the same time.
9.TRIGGERS / IR /
a.ALL TRIGGERS : Disabled
b.SET TRIGGER 1
c.SET TRIGGER 2
d.SET TRIGGER 3
e.SET
f.BAUD RATE : 19200
g.FLOW CONTROL : None
h.
All Triggers:
When on ‘Disabled’ all triggers remain off. When on ‘Enabled’ the trigger chart below is used to set conditions. For custom installations,
Set Trigger:
Highlighting ‘b. SET TRIGGER 1’ and then pressing SELECT displays this menu – in the example shown, TRIGGER 1 activates whenever MAIN power is turned on:
9b. SET
|
|
| MAIN | Z2 | Z3 | REC |
a. | POWER ON : | * | – | – |
| |
b. | CD | : | – | – | – | – |
c. | : | – | – | – | – | |
d. | : | – |
|
|
| |
e. | TAPE | : | – | – | – | – |
f. | FM/AM | : | – | – | – | – |
g. | DVD | : | – | – | – | – |
h. | TV | : | – | – | – | – |
i. | SAT | : | – | – | – | – |
j. | VCR | : | – | – | – | – |
k. | AUX | : | – | – | – | – |
Under each of the four Paths, MAIN, ZONE2 (Z2), ZONE3 (Z3), and RECORD (REC), notice that there are 40 available Sources (40 dashes) that could be used to activate the trigger. After highlighting POWER ON or a Source, press SELECT and use the buttons to move from one Path to another, and then to set the trigger to activate, use the buttons to change the
59