Service Manual

AOCe941series

By select

this “F” button to enter Factory OSD Menu.

9.4Writing DDC program step

After replacing the Main board and the Panel, Check if white-balance is within the specs ,then re-writing DDC is necessary.

1.Prepared the PC with Windows XP system, DDC recording device (12V)for figure below

2.Connect the DDC recording device and the PC through PC parallel port

3. setup “Port95nt” driver program to PC ,

4. select relevant program and run it, below figure will appear

5, Press “LoadFile”, select EDID -model of product, and select input port; 6. key in SN,and other informatiom, key-press “Pragram” button;

45

Page 45
Image 45
AOC E941VA, E941SA service manual Writing DDC program step