Turn On the Back-UPS
Press the Power ON button located on the top of the
The
If the red Building Wiring Fault LED located on the side of the
Operation
Energy Saving Master and Controlled by Master Outlets
When this feature is enabled, a device plugged into the MASTER outlet will act as the master on/off switch for devices plugged into the CONTROLLED BY MASTER outlets. Turn off or place in Standby mode the device plugged into the MASTER outlet and automatically all devices plugged into the CONTROLLED BY MASTER outlets will turn off. When the device plugged into the MASTER outlet is turned on or is taken out of standby mode, all devices plugged into the CONTROLLED BY MASTER outlets will automatically turn on.
Press and hold the Enable Master button for one second to enable or disable the feature. The Enable Master LED will illuminate green when the feature is enabled. There is no LED illumination when the feature is disabled.
Program the Threshold Settings
Some computers consume so much power that the MASTER outlet does not recognize the reduced power level of standby mode. In this case the CONTROLLED BY MASTER outlets will not shut off power to connected devices. When this occurs the threshold setting should be adjusted. Before adjusting the threshold setting verify that the Enable Master LED is illuminated green.
If the devices connected to the CONTROLLED BY MASTER outlets do not shut down when the MASTER device goes into Standby mode, increase the threshold setting to high.
To change the threshold setting:
1.Plug the
2.Press and hold the ENABLE MASTER button for 10 seconds, after which all the LEDs will flash. The
3.Release the ENABLE MASTER button and the LEDs that remain illuminated indicate the current threshold setting.
4.Press the ENABLE MASTER button to change the threshold setting.
Refer to the table below for threshold settings.
|
|
|
Illuminated LED Flashes | Threshold Setting | Input wattage Range in |
Standby/Sleep Mode | ||
Master Enable LED | Low | 10 Watts |
Master Enable LED, OnLine LED | Medium (factory default setting) | 25 Watts |
Master Enable LED, OnLine LED, | High | 60 Watts |
Replace Battery LED |
|
|
4 | Installation Guide |