Apex Digital PA40 manual Absolute Maximum Ratings, Specifications

PA40	ABSOLUTE MAXIMUM RATINGS
	SPECIFICATIONS

ABSOLUTE MAXIMUM RATINGS

SUPPLY VOLTAGE, +VS to –VS	250V
OUTPUT CURRENT, continuous within SOA	60 mA
OUTPUT CURRENT, peak	120 mA
POWER DISSIPATION, continuous @ TC = 25°C	14W
INPUT VOLTAGE, differential	±16 V
INPUT VOLTAGE, common mode	±V S
TEMPERATURE, pin solder – 10 sec	220°C
TEMPERATURE, junction2	150°C
TEMPERATURE, storage	–65 to +150°C
TEMPERATURE RANGE, powered (case)	–40 to +125°C

SPECIFICATIONS			PA40
PARAMETER	TEST CONDITIONS1	MIN	TYP	MAX	UNITS
INPUT
OFFSET VOLTAGE, initial			15	30	mV
OFFSET VOLTAGE, vs. temperature4	Full temperature range		70	130	µV/°C
OFFSET VOLTAGE, vs supply			20	32	µV/V
OFFSET VOLTAGE, vs time			75		µV kh
BIAS CURRENT, initial			50	200	pA
BIAS CURRENT, vs supply			2	20	pA/V
OFFSET CURRENT, initial			50	200	pA
INPUT IMPEDANCE, DC			1011
INPUT CAPACITANCE			5		pF
COMMON MODE, voltage range		±VS–12			V
COMMON MODE REJECTION, DC	VCM = ±90V DC	84	94		dB
NOISE, broad band	10kHz BW, RS = 1K		50		µV RMS
NOISE, low frequency	1-10 Hz		110		µV p-p
GAIN
OPEN LOOP at 15Hz	RL = 5K	94	106		dB
BANDWIDTH, open loop			1.6		MHz
POWER BANDWIDTH	CC = 10pf, 280V p-p		26		kHz
PHASE MARGIN	Full temperature range		60		°
OUTPUT
VOLTAGE SWING	IO = 40mA	±VS–12	±VS–10		V
CURRENT, peak5				120	mA
CURRENT, continuous		60			mA
SETTLING TIME to .1%	CC = 10pF, 10V step, AV = –10		12		µs
SLEW RATE	CC = OPEN		40		V/µs
CAPACITIVE LOAD	AV = +1	10			nF
RESISTANCE6, n o load	RCL = 0		150
RESISTANCE6, 20 mA load	RCL = 0		25
POWER SUPPLY
VOLTAGE3	See Note 3	±50		±125	V
CURRENT, quiescent			1.6	2.0	mA
THERMAL
RESISTANCE, AC junction to case6	F > 60Hz		5.9	6.85	°C/W
RESISTANCE, DC junction to case6	F < 60Hz		7.7	8.9	°C/W
RESISTANCE, junction to air	Full temperature range				°C/W
TEMPERATURE RANGE, case	Meets full range specifications	–25	25	+85	°C

NOTES: 1. Unless otherwise noted TC = 25°C, CC = 18pF, RC = 2.2K. DC input specifications are ± value given. Power supply voltage is typical rating.

2.Long term operation at the maximum junction temperature will result in reduced product life. Derate internal power dissipation to achieve high MTTF.

3.Derate maximum supply voltage .5 V/°C below case temperature of 25°C. No derating is needed above TC= 25°C.

4.Sample tested by wafer to 95%.

5.Guaranteed but not tested.

CAUTION

The PA40 is constructed from MOSFET transistors. ESD handling procedures must be observed.

APEX MICROTECHNOLOGY CORPORATION • 5980 NORTH SHANNON ROAD • TUCSON, ARIZONA 85741 • USA • APPLICATIONS HOTLINE: 1 (800) 546-2739