1.3Microphone (XMT) Selection (All models)

There are six pushbuttons associated with the communications transceivers. The

lower buttons control which transceiver is selected for transmit.

The SL15-CD gives priority to the pilot’s PTT. If the copilot is transmitting, and the pilot presses his PTT, the pilot’s microphone will be heard over the selected communications trans- mitter.

RCV

XMT

The SL15-CD has an automatic selector mode. Audio from the selected transceiver is automatically heard in the headsets and speaker (if SPR selected). You can check this function by switching from COM 1 to COM 2 and watch the selected audio light on the selector change from COM 1 to COM 2. This ensures the pilot will always hear the audio from the transceiver he is transmitting on.

When switching from COM 1 to COM 2, while COM 2 audio had been selected, Com 1 audio will continue to be heard. This eliminates the pilot having to switch Com 1 audio back on, if desired.

When switching from COM 1 to COM 2 while Com 2 has NOT been selected, Com 1 audio will be switched off. In essence, switching the mic selector will not effect the selection of Com receiver audio.

When the duplex, or TELEPHONE mode is implemented, Com 3 becomes the “TEL” position. This is the pilot’s “hook” switch, when the system is interfaced to an appropriate approved wireless telecommunication system, such as the Air- Cell system. Placing the mic selector in Com 3 places the pilot microphone and headphones on the cellphone. The pilot PTT will switch the pilot mic to the other selected com transceiver, and allow continued aircraft communications as well. The copilot will also be able to transmit with his PTT as well.

NOTE

Placing the mic selector switch in the COM 3 –TEL– mode will disable pilot and copilot intercom, as the intercom circuit is transferred to the telephone use. In crew or ISO mode, placing the switch in TEL mode removes the passengers access to the telephone.

1.3.1Swap Mode (Switch from Com 1 to Com 2 remotely)

With a yoke mounted, momentary switch, the pilot can change from the current Com transceiver (Com 1 or 2) to the other by depressing this switch. To cancel "Swap Mode," the pilot may either press the yoke mounted switch again, or select a different Com with the XMT buttons.

Page 4