Apple bCool XG1 7.Troubleshooting

If a fault occurs, first check the points listed below before taking the projector for repair.

If you are unable to remedy a problem by following these hints,consult your dealer or service

organisation.

Under no circumstances should you try to repair the projector yourself as this could invalidate the

guarantee.

– Possible cause

•Solution

General

– Mains lead is not correctly connected.

•Correctly connect mains lead.

– Lamp holder cover is not closed correctly or the lamp holder is damaged.

•Close the cover correctly (see ‘Lamp replacement’under ‘Maintenance’).

– Signal cable not correctly connected.

•Connect signal cable correctly.

– The projector is in Off position.

•Press Standby to switch on the projector.

– A/V Mute active.

•Cancel A/V Mute.

In Video series mode

– Keystoning is applied on a high resolution component signal.

•Decrease keystoning until the image is correctly displayed.For this use the ‘Keystone’ option

in the ‘Setup’menu.

In Data mode

-- Partial,scrolling or incorrectly displayed image.

•Use the ‘Autosync’option in the ‘Picture’ menu.

– Input resolution is too high (and keystoning is applied).

•If you wish to keep the keystone correction, decrease the input resolution until the image is

correctly displayed. For this,refer to the User Guide or support infor mation of the

computer.

•If you wish to keep the input resolution as it is,decrease keystoning until the image is

correctly displayed. For this,use ‘Keystone correction’ option in the ‘Settings’menu.

– Input resolution is too high (and no keystoning is applied).

•Decrease the input resolution until the image is correctly displayed. For this,refer to the

User Guide or support information of the computer.

Problem

Philips Multimedia Projector 27 English User guide bCool XG1

7.Troubleshooting