Set time and day, Understanding program schedules, Set temps

Operation & Programming

Set time and day

1..Press to enter time setting mode.. Hour and AM/PM are flashing..

2..Press or to adjust the hour..

3..Press , the minutes flash.. Press or

to adjust the minutes..

4..Press , the day flashes.. Press or

to adjust day..

5..Press to end. “DONE” will display.

The thermostat will return to normal mode if no key is pressed within 3 seconds..

The daily schedule is split into four sections:

WAKE: 6am-8am – Temperature you would prefer to wake up to, until you leave for the day.

LEAVE: 8am-5pm – Temperature when you are away from the house during the day..

RETURN: 5pm-10pm – Temperature you would prefer to return to, until bedtime.

SLEEP: 10pm-6am – Temperature you would prefer during the night..

The times shown are the defaults.. The start time and temperature of each section can be changed to fit your schedule (see page 10)..

Operation & Programming

The Progressive Recovery feature allows the thermostat	Example:
to activate the heating and cooling equipment prior to	Set the Wake time to 6 am, and the temperature to 70°.
an event in order to reach the desired temperature at	The heat will come on before 6 am, so the temperature
the start of the next scheduled event..	is 70° by the time you wake at 6.