ARDISAM
OPERATION
REGISTRATION FORM
Complete and return. Your powerhead has a model/serial number decal located on the muffler side of the engine. Record this number and the model number in the space provided on page 2 of this manual.You will need these numbers if you order parts. Fill out and mail the registration card located in your parts packet. Warranty is valid only if your completed registration card is received by Ardisam, Inc., at time of purchase.
OPERATION
CAUTION
Please do not start your earth auger unit until you have read the Engine Manual that came with your engine, and the section in this manual titled Safety. If you have read these, follow the steps below to start your earth auger unit. Always perform
SPARK PLUG INSTALLATION
If your powerhead does not have the spark plug already installed for you.You will have to install it following the instructions given below.
1.Locate the spark plug in the parts packet.
2.With powerhead laying on side labeled "THIS SIDE UP WHEN NOT IN USE," place spark plug in spark plug hole. For replacement use Champion
NOTE: A resistor spark plug must be used for replacement.
3.Turn by hand until snug.
4.Use a wrench or socket to tighten to 180
DO NOT OVERTIGHTEN.
1.Read engine manual and follow instructions for fuel type, starting, etc.
2.The clutch will transfer maximum power after about two hours of normal operation. During this
3.The earth auger unit should be operated no more than 20 degrees in any direction during continuous use and limited to 30 degrees intermittently. Recommended for adequate lubrication and fuel delivery.
CAUTION
It is recommended that the earth auger unit not be tilted at more than a 30° angle from the upright position. Failure to do so can cause fuel and/or oil leakage.
4.When digging in heavy soil, pump the earth auger unit with an up and down motion in the hole for every one foot of depth.
5.Never run engine indoors. Exhaust fumes are deadly.
6.Do not use an earth auger in ice.
WWW.ARDISAM.COM | Page 4 |
