GB - 9
CARTON CONTENTS
ASSEMBLY
1. Remove mower and handlebar from
carton.
2. Install the handlebars on the pivot pins
attached to the handlebar uprights.
NOTE: Make sure the cables (connected to
the handlebar) are on the left side of the unit.
3. Remove the handlebar mounting
hardware from the handlebar uprights.
4. Rotate the handlebar up or down to the
desired height and align the mounting
holes with the holes in the handlebar
upright.
5. Secure the handlebars in position with
hardware removed in step 3.
6. Connect the engine/blade control cable
to the engine.
Route the z-bend cable end into engine
shutoff lever as shown below.
Insert the cable connector into the cable
mounting bracket on the engine. Make
sure the connector snaps into place
securely.
ASSEMBLYCAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Figure 3
1. Mower Unit
2. Mulch Cover
3. Side Discharge Chute
4. Mulch Plug
5. Literature Pack
6. Grass Bag
1
2
3
54
6
OM1706
Figure 4