ASSEMBLY

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

WARNING: Dropping or tipping over boxed unit could result in personal injury or damage to unit.

PACKAGE CONTENTS

2

3

 

.

1

2

3

1. Shift Rod

4

2. Wing Knob

and Bolt

 

4

3. Wing Nut and

Bolt

4. Handlebar

Figure 4

OS8025

1

 

OS8020

1. Sno-Thro Unit

4. Literature Pack with

2. Discharge Chute

Extra Shear Bolts

3. Chute Rod

Figure 3

ASSEMBLY

Tools Required:

•Pliers

•Open-End Wrenches: 3/8, 7/16, 1/2, 9/16 in. and/or Adjustable Wrench

•Tire Gauge

Unfold Handlebar (Figure 4)

1.Remove the lower and loosen the upper wing knobs on the handlebar assembly.

2.Loosen the wing nuts on the shift rod.

3.Put the speed selector lever in the sixth forward position.

4.Rotate the handlebars into operating position.

5.Install and tighten all wing knobs and wing nuts on the handlebar assembly and shift rod.

Install Discharge Chute (Figure 5)

1.Grease underside of discharge chute ring (if not already greased).

2.Remove mounting hardware from the bottom of the chute pedestal.

3.Install discharge chute over opening in the auger housing and secure pedestal to auger housing with hardware removed in step 2.

 

1

2

 

3

 

1

4

 

1. Mounting Hardware

 

2. Discharge Chute

 

3. Discharge Chute Ring

 

4. Chute Pedestal

 

 

OS8030

Figure 5

Install Discharge Chute Crank

1.Slide Chute Crank through the nylon bushing in the support bracket.

GB - 7