Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 920022 Step Three Install Discharge Chute, Remove mounting hardware from auger housing

Models: 920022

1 25

Download 25 pages 40.74 Kb

Page 4

Step Three:

Step Three:

Install Discharge Chute

1.Grease underside of discharge chute ring (if not already greased).

2.Remove mounting hardware from auger housing

3.Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed above.

NOTE: Leave discharge chute pedestal loose to help install the chute crank.

Image 4

Ariens 920022 Step Three Install Discharge Chute, Grease underside of discharge chute ring if not already greased

Contents

Quick Start Guide Compact 24 LET 920022 s/n 000101 & upStep One Assemble Handlebar Step Two Install Trigger Cable Assembly NOTICE Trigger cable assembly comes attached to the Sno-Thro unit2. Remove mounting hardware from auger housing Step Three Install Discharge Chute1. Grease underside of discharge chute ring if not already greased Step Four Install Discharge Chute Crank Step Five Install Remote Deflector Cable Step Five Install Remote Deflector Cable Cont Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Check oil level in auger gearcase Step Nine Check Auger Gearcase Oilsee Check Auger Gearcase in Owners Manual Step Ten Check Engine Crankcase Oil IMPORTANT The engineFill fuel tank. DO NOT OVERFILL! See Step Eleven Fill Engine Fuel TankFILLING FUEL TANK in Step Twelve Starting the EngineStarting Engine / Step A Choke Turn choke ONStarting Engine / Step B Rocker Switch Push rocker switch to RUN positionStarting Engine / Step C Fuel Shut Off Valve Turn fuel petcock to ON positionStarting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Press and hold starter buttonStarting Engine / Step H Warm up CHOKE OFF positionOR Pull Safety Key from Engine Under normal conditions 1. Push rocker switch to STOP position2. Pull safety key OUT Step Thirteen Stopping the EnginePhone 2013 The Ariens Company. All rights reservedAdditional Resources Refer to Owners Manual and Engine Manual Contact Ariens Company