Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 921030 quick start Step Three Install Discharge Chute Crank

Models: 921030

1 28

Download 28 pages 57.56 Kb

Page 10

Step Three: Install

Step Three: Install

Discharge Chute Crank

1.Remove the gear cover from top of chute pedestal.

2.Insert the short end of the chute crank into the hole in the front of the control panel.

NOTE: Be careful not to damage nylon bushing when attaching crank to the dash.

3.Connect the chute crank to the pinion gear on chute with hairpin.

4.Replace gear cover on top of chute pedestal.

5.Orient the chute and pedestal to its most vertical position and tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).

Image 10

Ariens 921030 quick start Step Three Install Discharge Chute Crank

Contents

Quick Start Guide Deluxe 28 921030 s/n 101 & upStep One Assemble Handlebars Not attachedStep One Assemble Handlebars Unfold Lower Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Upper Handlebar Assembly NOTE This slide applies to UNATTACHED handlebars ONLYNOTE Make sure the cable remains in the groove of the pulley Step One Assemble Handlebars Attach Control Cables1. Hook spring end of attachment control cable to the clutch arm NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Unfold Upper Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Connect Headlight Wire Harness NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebar NOTE This slide applies to ATTACHED handlebars ONLY2. Remove mounting hardware from auger housing Step Two Install Discharge Chute1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Skid Shoes in Owners Step Seven Adjust Skid ShoesManual Check oil level in auger gearcase Step Eight Check Auger Gearcase Oilsee Check Auger Gearcase in Owners Manual Step Nine Check Engine Crankcase Oil Ariens AX IMPORTANT The engineFILLING FUEL TANK in Step Ten Fill Engine Fuel Tank Ariens AXFill fuel tank. DO NOT OVERFILL! See Owners ManualStep Eleven Starting the Engine Ariens AXStarting Engine / Step A Choke Turn throttle all the way up. Turn choke ONStarting Engine / Step B Rocker Switch Push rocker switch to RUN positionStarting Engine / Step C Fuel Shut Off Valve Turn fuel petcock to ON positionStarting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Press and hold starter buttonStarting Engine / Step H Warm up CHOKE OFF positionAdditional Resources E-mail info@ariens.com