GB - 15
Attachment Clutch - Right Hand LeverSqueeze Attachment
Clutch Lever against
handlebar (1) to engage
attachment. Release
both clutch levers (2) to
disengage power and
apply brake to
attachment.
IMPORTANT: If the belt
squeals when the
attachment clutch lever
is engaged, the
attachment drive may be frozen. Immediately
release the attachment clutch lever and move
the unit into a heated area to thaw.
Ignition Switch (120V start on engine)Key Switch has two positions:
1. “Stop” - pulled out
2. Run - pushed in
NOTE: DO NOT twist key after
it is inserted.
Ignition Switch (12V start on dash panel)The ignition switch is
operated by a removable key.
It has three positions:
1.Stop
2.Run
3.Start
Primer BulbPushing the primer bulb in adds
fuel for easier engine start.
Refer to Starting and Shut Off.
Speed SelectorThe Speed Selector controls the unit travel in
a forward or reverse direction when positioned
in notch of speed.
Forward:
(6) Fastest
(1) Slow
Reverse:
(1) Slow
(2) Fast
IMPORTANT: DO NOT
change motion from
forward to reverse with
clutch engaged.
Forward speed can be
changed without
declutching.
Choke Control Knob1. Choke Closed position:
chokes off air to engine for
easier start.
2. Choke Open position:
allows for normal
operation.
IMPORTANT: Gradually
open choke after engine
starts.
ThrottleThe throttle controls the engine
speed. To increase or decrease
the engine speed, adjust to:
1. Fast (normal or warm starts)
2. Part-Throttle
3. Slow (cold weather starts)
4. Stop (engine is off)
Electric Starter The electric starter will start a properly choked
and cranked engine when the key is turned
(12V) or starter button (120V) is pushed. Refer
to Starting and Shut-Off.
Recoil Starter Handle When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back
against starter.
1
2
OL2691
1
2
OS1431
OS0232
123OS1321
OS1191
1
2
6
5
4
3
2
1
1
2
OS1332
STOP
1
2
3
4
OL2720