Date: Jul. 22, 2011 No.
7.Install drive belt and accessory belts (Figure 6).
8.Install belt finger (B) and retain with hardware removed earlier (Figure 6). Torque to 132
9.Ensure proper belt finger clearance:
•With attachment clutch engaged belt finger on the side opposite the belt idler should have a maximum clearance of .125” from belt without touching.
B
Figure 6
10. Replace belt cover.
Remove Protective Cover From Recoil Housing
1.Remove the plastic protective covering from the recoil housing. Engine overheating and potential damage can occur if left in place.
Figure 7
Page 4 of 4