MARGHERITA
Margherita - Instructions for installation and use
12
3

EF

DHG

B

CA

I

Drying cycle lamp
When this lamp is on, it means
that knob B has been set on a
drying cycle and at the end of the
wash cycle, the appliance will run
the selected tumble drying cycle.
only to be used with wash
programmes for synthetic fabrics,
silk and curtains when it is
impossible for you to take the
washing out immediately. Before
opening the washing machine
door, finish the wash cycle as
follows:
Silk and curtains: press button D
and Margherita will drain the
water.
Synthetic fabrics: press button D
if you want a spin cycle, or turn
knob A to symbol if you want
the water to be drained.
N.B.:
- when setting a drying cycle,
this function is not performed.
- with "Daily wash" or "Hand
wash", this function is not
performed.
Slow spin
Use this button to reduce the
spinning speed from 1000 to 500
rpm for the cotton programmes
and from 850 to 500 rpm for the
synthetic fabrics programmes.
On-off
When button F is pressed, the
washer-dryer is switched on,
when it is not the machine is
switched off. Turning the
appliance off does not cancel
the selected programme.
On-off lamp / door locked
Lamp G flashes slowly when the
appliance is switched on and
awaiting instructions and at the
end of a cycle, indicating that the
door can be opened. It flashes
quickly when the door should not
be opened. A steady light means
the appliance has accepted the
selected programme.
Here Im in command

Understanding the control panel

Making the right choice is important. And its easy.
Programme selector knob
and programmed start
Use this knob to select the wash
programme.
Turn this knob clockwise only.
To select a programme, you
should turn the knob so that the
symbol/number of the desired
programme is in line with the
pointer on the glass I.
Now press on/off button F
(position ON), pilot lamp G will
start flashing.
After 5", the setting will be
accepted, pilot lamp G will stop
flashing (staying lit) and the wash
cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols
(Stop/Reset) and wait
5" : when the cancellation has
been accepted, pilot lamp G
flashes, and you can then turn the
appliance off.
You can use this knob to delay
the appliance's operation.
Select one of the 3 delay time
positions, press the on/off button
F (position ON) and wait 5". The
setting has now been accepted
(pilot lamp G stays lit) and you
can select the programme you
desire.
Pilot lamp G has a particular
flashing motion (2" on and 4"
off) to indicate that a delayed
start has been set.
During this phase, you can open
the appliance door and change
the washing load, should you
wish to do so.
After the wash cycle has been set
and accepted by the washer-
dryer, turning the knob will have
no effect (except for when it is
on position Stop/Reset).
Drying cycle knob
Use this knob to select the desired
drying cycle. Two options are
available:
A - Based on time:
From 40 minutes to 150.
B - Based on the damp level of
the dry clothes:
Iron : slightly damp clothes,
easy to iron.
Wardrobe : dry clothes to put
away.
Extra dry : very dry clothes,
recommended for towelling and
bathrobes.
A cooling stage is foreseen at the
end of the drying cycle.
Detergent dispenser
It is divided into three compart-
ments:
1.Detergent for pre-washing;
2.Detergent for the wash cycle;
3. Fabric softeners, starches,
perfumes.
Rinse-hold
This button allows you to
interrupt a programme (on symbol
) keeping the washing soaking
in water before the spin cycle. It
is a very useful button in
particular because it can be used
for delicates and synthetics. It is
The detergent dispenser is here.
3
Margheritas knobs are hidden. Just
press them lightly in the middle to
extract them.