Starting the dishwasher
Ready, steady, go!
You have loaded your dishes and you now have to set the wash cycle. It takes just one minute to learn how
After performing all the operations described in the previous paragraphs,if accessible turn the water tap on, open the appliance door and press
Your appliance is now on and awaiting instructions.
You've left out a dish?
Well, it happens to everyone. Interrupt the wash cycle by opening the appliance door with the utmost care, as usual, then insert the dish you had forgotten. When you shut the appliance door, the cycle will start up from where you interrupted it.
Selecting the wash cycle.
Select the wash cycle by pressing button "P". Each time this button is pressed, one of the indicator lights "M" will come on in sequence, select the wash cycle you deem most suitable for the type of dishes to wash (take a look at page 7, where you will find the wash cycle table). Close the appliance door and after a few seconds, you will hear a short beep: the wash cycle has begun.
Modifying a wash cycle in progress.
If you have chosen the wrong cycle, not to worry! You can modify the wash cycle in progress, if it has only just started. Open the appliance door carefully to avoid any hot water splashes, then keep button "P" pressed for approximately 5 seconds, until you hear a short beep. Indicator light "M" will come off and at this point, all the settings will have been cancelled. You are now free to
Finished?
The end of the wash cycle is indicated by a double beep and the flashing of the wash cycle indicator light "M". Open the dishwasher door, press the
If accessible turn off the water tap.
Wait a few minutes before unloading the dishes: they are very hot! If you wait a little while, they dry better thanks to the steam.
Empty the lower rack first.
If opening the door soon
after the end
of the program, or
during it, stand away from the Dishwasher, to avoid possible injury from hot steam.
There's been a power failure? Have you opened the dishwasher door?
The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. Everything is under control!
Do you want extra drying?
Press button "E" before you start the selected wash cycle. A long beep will tell you that you have selected extra drying and the wash cycle will last longer in order to provide you with drier dishes.
| You can cancel the |
| Make sure the wash |
|
|
| cycle has ended before |
| |
| wash cycle in progress, |
|
| |
|
| removing the dishes! |
| |
| if it has only just started. |
|
| |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
www.aristonappliances.us | ARISTON DISHWASHER - User Manual 5 |
