GN115 - GN014 I Windshield Suction Mount for GarminTM Nuvi®
Travel MountTM Windshield, Console, or Dash Mount for Garmin Nuvi® and StreetPilot® portable GPS navigation devices.
Compatible with ALL Garmin Nuvi portable navigation devices including: Nuvi 200, 250, 270, 300, 310, 370, 600, 610, 650, 670, 680.
Compatible with Garmin StreetPilot models c310, c340, c510, c530, c550, c580.
1.Choose the best location on vehicle to place the mount. Do not place mount in or near an air bag deployment zone or where it will obstruct view of the road.
2.Attach Nuvi to mount ball head by firmly pushing ball (A) into socket on the back of the device (B) as pictured below.
(17mm socket)
(B)
(A)
(17mm ball head)
3.Push the pedestal suction cup (C) firmly to the windshield. Flip the lever (D) toward base to secure the suction cup.
(C)
(D)
4.Adjust the angle of the arm by loosening the adjustment knob (E).
5. Position the Nuvi as desired
(E)
360o swivel
6.To remove, hold the pedestal with one hand and firmly pull Nuvi away from pedestal with your free hand.
Installation for optional Console Dash Mount (GN115)
1. Remove paper liner from adhesive on mount disk | 2. Push the pedestal suction cup (A) down onto the | ||
and affix adhesive to the dash. Let stand (at room | disk (D). Flip the lever (B) down to secure the | ||
temperature) for 24 hours before using. | suction cup. Adjust the angle of the arm by | ||
|
|
| loosening the adjustment knob (C). Poistion Nuvi as |
|
|
| desired. |
Removal of Dash Mount
To remove the dash mount completely, use a cotton swab dipped in isopropyl alcohol. Simply peel up a corner of the dash mount adhesive and swab under the pad while gently pulling until the adhesive begins to release. Remove slowly. No damage will occur from the adhesive if it has been properly installed and removed per these instructions. You may see a slight discoloration between this area and other parts of your dash due to fading caused by the sun.
(C)
(B)
(A)
(D)
!WARNING:
Do not install Arkon products over an air bag cover or within the air bag deployment zone. Arkon Resources, Inc. assumes no responsibility of liability for injury or death as a result of car crashes and/or air bag deployment.
Arkon Resources, Inc. is not responsible for any damages caused to your car, your device, or yourself due to the installation or use of the pedestal mount.
The Mobile Mounting Specialistsô
Consumer Hotline: | www.arkon.com |
(USA) (800) | Arcadia, CA 91006 USA |
(INTíL) (626) | Made in Taiwan |
© Copyright 2008 Arkon Resources, Inc. |
