AOS.33 Operations Manual
BEFORE IN5TALLATtON:
1.This system operates from 10 volts DC to 38 volts DC, negative ground
2.Please install this system according to the instructions in this manual.
3.Do not disassemble the camera or the monitor. This voids the warranty Disassembling the camera Will compromise the waterproof sea!
4.Connect the system to an ignition switched power source. Connection to a battery source will reduce battery life
**WARNING**
, .It) | pTeve"1 e\~t:.1f\C'd\"'\)t)C". DO NO'. oPEN '.HE tAON\TOR |
| monitor. There are no user serviceable parts inside. If evidence of tampering is detected, the warranty will be |
considered void.
2.Keep monitor away from leaking water, rain, moisture etc, It is NOT waterproof, Any moisture inside the monitor could cause extensive damage,
~.Use \ne \numbscrews \0 moun\ \he rT1on'l\orto bracket,
**CAUTION** |
|
'\ .DO | NOT OPEN THE CAMERA CASE. This will break the camera's waterproof seal. If evidence of tampering is |
detected. the warranty will be considered void.
2.Do not molJnt the camera near the lower area of the vehicle (e.g. Bumper). This reduces the view of the camera and may cquse physical damage to tne camera
3.Use only the M4x8 bolts and washers to mount the camera
INSTALlATION INSTRUCTIONS
Acc.rs | CAMERA |
1.Attach | camera bracket (See Fig 1) to upper portio~ of vehicle. Attachment point must be s'urd)' enough 'I:>suppon |
camera and bracket.
2- Att~ch camera to bracket using M4x8 bolts provided. Adjust angle as indicated in figure 2 (Use rear bumper and
back of vehicle as a reference point
~.W\tld dei\ectof ma~ 00 \m\a\\~.I"is Ue"~I:;\Ofis desig"~d \0 r~t\ut:.e\ne bIJi\6 up 0\ du\;\, d\rt and mo\S\uTe on the camera lens (See Fig 3).
AOM.70 MONiTOR
1.Att'i1ch monitor ins\;je veh\cle in a location conven\£!nt to the dri~er (e.g. center of dash, overhead or in dash). (See Fig 4)
2.Use a compression plate l!) attech the monitor bracket to the dash or overhead (See Fig 4).
3.Adjust !T\ounting a!)gle of the monitor to allow driver to easily view the screen from all seat positiOn$ (See Fig .5) .
4.If necessary, snap sun visor into groove on front face of monitor. Press a\l (4) sid£!s of the visor to ~nap it into
1.The
2.Do not run the
3.Place all
4.Wire tie the cable securely.
Page 2 of 14