5-4 Input Signal Detection
Tuner system will detect a signal if a signal is received in every
mode
of signal input. If there is no signal, the screen will display “No
Signal”.
Otherwise, the signal will be displayed showing the mode.
5-5 Channel Selection
Use s or t button for channel selection.
If you auto-programmed the channels into memory, the s or t
button will do channel steps up or down through the
memorized
channels. For more information about detail descriptions of
auto
program, please refer to section 3. If the auto-programming
was not
done, the channels will be displayed sequentially even if no
signal is
present.
5-6 Channel Recall
Press s or t on the channel button to display the channel
information.
5-7 Contrast/Color/Brightness Adjustment
If you want to adjust Contrast/Color/Brightness, press the
appropriate
button. The screen will display the one you choose, then use
Volume
s or t to adjust it. If you take over 2.5 seconds to adjust, the
screen
display will disappear and the buttons will reset to s or t
Volume.
The scales of adjustment are in 16 steps.
5-8 Volume Adjustment
Use the Volume s or t buttons to increase or decrease the
audio
volume.
You will see “Volume Bar” on the screen display.
The scales of volume adjustment are in 16 steps.