GX4manual020501.fm Page 7 Monday, February 5, 2001 1:39 PM
User’s Manual
Optional: Placing or Rack Mounting the Switch
The GX4 switch comes with four rubber feet for placement on a flat surface.
Placing the GX4 on a flat surface:
1.Apply the four rubber feet to the bottom of the unit
2.Put the unit on the flat surface
Mounting the GX4 in a Rack:
1.Place a mounting bracket over the mounting holes on each end of the unit
2.Insert each screw through the bracket and into a mounting hole in the switch as shown in Figure 6.
3.Insert the unit into your equipment rack, and attach with screws provided.
| Figure 6. FriendlyNET GX4 Optional Rack Mounting Bracket | ||
Troubleshooting |
|
| |
|
|
|
|
| Symptom | Corrective Action |
|
|
|
|
|
|
|
|
|
| Power LED is off | Make sure the power cord is connected to the power outlet and power |
|
|
| connector on the rear of the unit. |
|
|
|
|
|
| Fast blinking 100M Link, | AsantéQ has detected a low |
|
| 1G Link, or 1000 LEDs |
|
|
|
|
|
|
| Slow blinking 100M Link, | AsantéQ has detected receive bit errors. Check for faulty Ethernet adapters or |
|
| 1G Link, or 1000 LEDs | other network devices.Verify network cable. |
|
|
|
|
|
| 100M Link, 1G Link, or | No link established.Verify network cable. |
|
| LNK/SPD LED is off |
|
|
|
|
|
|
|
| Table 3. Troubleshooting | |
|
|
|
|
|
| – 7 – | |
