| TECHNICAL NOTES & SPECIFICATIONS |
|
|
ARCHITECTS SPECIFICATIONS
| shall be used. Each channel shall have a PROTECT LED which |
The power amplifier, being of two channels, shall deliver a mini- | indicates an open relay due to |
mum power of 185 watts RMS per channel into 8 ohm loads and | on delay. The power output devices shall be of the Lateral MOS- |
275 watts RMS per channel into 4 ohm loads, or 275 watts per | FET type. |
channel into 2 ohm loads with both channels operating. When | The amplifier shall weigh 41lbs net and mount in a standard 19 |
switched into | |
least 370 watts into a 16 ohm load, and 550 watts RMS into an 8 | inch rack using two spaces (3.5 high). The power requirement shall |
ohm load. The amplifier shall be immune to damage from shorted, | be |
open, or mismatched loads. The amplifier shall have a gain of 29 | |
dB |
|
2% for full rated output. Frequency response shall be 20Hz to |
|
20kHz |
|
capacitors and inductors. Hum and noise shall be at least 100dB |
|
below full output and SMPTE intermodulation distortion shall be |
|
less than .01% at full output. The amplifier shall have rear panel |
|
switching for parallel mono and bridging modes and rear mounted |
|
level controls. The inputs shall be of balanced bridging type with |
|
barrier strip, 1/4 phone jacks, and female XLR connectors. A |
|
| |
power level of each channel and self contained forced air cooling |
|
|
|
Features:
Fuseless Short Circuit Protection
U.L. Listed
Modular Construction
XLR, 1/4", and Barrier Strip inputs
Stereo, Parallel Mono & Bridging Modes
LED Level meters
Forced Air Cooling
Perfect Overload and Square Wave Response
Stable Into Any Load
Self Protecting Under Virtually All Conditions
Input Transformers Optionally Available
PowerCard Input Option Ready