Asko D3432 Troubleshooting, Removing Hard Water Spots from Dishes, Before YOU Call

REMOVING HARD WATER SPOTS FROM DISHES

To remove hard water spots, try the following:

1.Run dishes through a normal wash program.

2.Remove all metal dishware, such as cutlery, pans, etc., from the dishwasher.

3.Do not add detergent.

4.Pour two cups of vinegar into a bowl and set the bowl face up on the bottom rack of the dishwasher.

5.Run the dishes through a Normal wash program.

If this doesn’t work, try the same process with 1/4 cup of citric acid crystals (available at most drug stores) instead of vinegar.

TROUBLESHOOTING

If you should experience a problem with your dishwasher, you should review the list of frequently encountered situations below. It could save you the cost and inconvenience of a service call.

Even though the product is under warranty, if the problem is not caused by defective product workmanship or materials, you will be charged for a service call. Refer to page 16 to determine what is and is not covered under your warranty. If you’re still not sure, contact the ASKO Advisory Center before you call a service technician.

BEFORE YOU CALL

Before calling for service or contacting ASKO regarding a warranty issue, make a note of the model name, type number and serial number. The model is on the front of the dishwasher. The type plate with the type name and serial number is located on the inside edge of the door. (See illustration at right.)

ASKO Advisory Center Phone Number: 972-238-0794 or 800-898-1879

Type plate

(see below)

Type Name

Type: DW20.x

12-digit

2345678901234567000000000000 Serial

Number

Detergent left in compartment

♦Be careful not to load items so close to the dispenser that the cover will not open to release the detergent.

♦The dispenser is not supposed to open when you use the Rinse program.

♦Your dishwasher detergent should be fresh and stored tightly closed in a cool, dry place. Old or caked detergent should be thrown away because it will not dissolve properly and will leave a gritty residue on the dishware.

♦Wait until you are ready to start the dishwasher to add the detergent.

♦If you are using the Delay program, make sure the dispenser is dry before adding the detergent.

♦The detergent compartment only opens in the main wash programs, not the Rinse program.

Dishwasher leaks

♦Use only unscented, granular automatic dishwasher detergent. Using a liquid detergent could cause oversudsing and leakage.

♦You should always use fresh detergent.

♦The amount of detergent needed for your dishes depends on the hardness of the water in your area. Contact your local utility company to learn the water hardness in your area then refer to the chart on page 5 to determine the amount of detergent you should use.

♦Be careful not to overfill the rinse aid dispenser. Spilled rinse aid could cause oversudsing and lead to overflowing. Wipe away any spills with a damp cloth.

♦Make sure the dishwasher is level. (See the installation instructions.)

Dishwasher makes unusual noises

♦This usually means that something is not loaded properly. Make sure the dishes are securely in place and that nothing has fallen between the basket tines. Also, place small items in the small items compartment and close the lid. (See page 4.)

Page 12

Dishwasher runs too long

♦If the temperature of the water entering your dishwasher is below 120°, the dishwasher runs longer because it heats the water to the proper temperature for the program selected. Raising your water heater setting may help to shorten the cycle times. If this doesn’t resolve the problem, call the ASKO Advisory Center.

Continued on next page.