2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!
Serial ATAII Connectors
(SATAII_1: see p.2, No. 14) | SATAII_2 |
| |
(SATAII_2: see p.2, No. 16) |
|
SATAII_1
These Serial ATAII (SATAII) connectors support SATAII or SATA hard disk for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate.
Serial ATA (SATA) | Either end of the SATA data cable |
Data Cable | can be connected to the SATA / |
(Optional) | SATAII hard disk or the SATAII |
| connector on the motherboard. |
|
|
USB 2.0 Headers | Besides four default USB 2.0 |
ports on the I/O panel, there are | |
(see p.2 No. 13) | two USB 2.0 headers on this |
| motherboard. Each USB 2.0 |
| header can support two USB |
| 2.0 ports. |
| |
(see p.2 No. 17) |
|
Front Panel Audio Header | This is an interface for front |
panel audio cable that allows | |
(see p.2 No. 15) | convenient connection and |
| control of audio devices. |
1.High Definition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the instruction in our manual and chassis manual to install your system.
2.If you use AC’97 audio panel, please install it to the front panel audio header as below:
1 3
English
ASRock
