
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, or RAID 10 configuration through the onboard controller.
SATA3G_1 SATA3G_2 SATA3G_3 | ||
|
| |
GND RSATA TXP1 RSATA TXN1 GND RSATA RXN1 RSATA RXP1 GND | GND RSATA TXP2 RSATA TXN2 GND RSATA RXN2 RSATA RXP2 GND | GND RSATA TXP3 RSATA TXN3 GND RSATA RXN3 RSATA RXP3 GND |
SATA3G_6
GND RSATA_RXP6 RSATA_RXN6
GND
RSATA_TXN6
RSATA_TXP6
GND
SATA3G_5
GND RSATA_RXP5 RSATA_RXN5
GND
RSATA_TXN5
RSATA_TXP5
GND
SATA3G_4
GND RSATA_RXP4 RSATA_RXN4
GND
RSATA_TXN4
RSATA_TXP4
GND
•These connectors are set to AHCI mode by default. If you intend to create a Serial ATA RAID set using these connectors, set the type of the SATA connectors in the BIOS to [RAID].
•You must install Windows® XP Service Pack 3 or later version before using Serial ATA hard disk drives. The Serial ATA RAID feature is available only if you are using Windows® XP SP3 or later version.
•When using
ASUS |