Follow these steps to install the hard disks for RAID configuration.

1.Install the Serial ATA hard disks into the drive bays.

2.Connect one Serial ATA HDD to each Serial ATA connector, using separate serial ATA cables.

4.Connect the power cable to the power connector on each drive.

5.Make sure that the Serial ATA jumpers are set to enabled. See “2.7 Jumpers, Serial ATA Setting (3-pin SATA_EN1)” for more detailed information on jumper settings.

6.Proceed to 5.9.2 for the next procedure.

5.5.2Creating and Deleting RAID sets

Creating and deleting RAID sets is a built-in function found in the BIOS. The following sub-sections describes how to use the RAID Configuration Utility.

Loading the RAID Configuration Utility

During POST, press <CTRL+S> or F4 to enter RAID configuration utility. The following menu options will appear.

Create RAID Set

Delete RAID Set

Rebuild RAID Set

Resolve Conflicts

Below this menu items are the listed drives installed on the system. The top right half of the screen displays the directions and comments for the user. The bottom right half lists the command keys.

↑ ↓

Select Menu

ESC

Previous Menu

Enter

Select

Ctrl-E

Exit

 

 

5-14

Chapter 5: Software support