IDE Primary Master/Slave IDE Secondary Master/Slave

IDE Primary Master

IDE HDD Auto-Detection

[

Press Enter

]

IDE Primary Master

[Auto]

Access Mode

[Auto]

Capacity

40020 MB

Cylinder

19158

 

Head

16

 

Sector

255

 

Transfer Mode

UDMA 2

Select Menu

Item Specific Help

To auto-detect the HDD’s size, head...on this channel.

F1

:

Help

↑↓ :

Select

Item

-/+

:

Change

Value

F5

:

Setup Defaults

ESC

:

Exit

→← :

Select

Menu

Enter

:

Select

Sub-menu

F10

:

Save and Exit

IDE HDD Auto-Detection [Press Enter]

Press enter to automatically detect an IDE hard disk drive, if the hard drive is not already detected. In cases of undetected HDDs, pressing enter will detect the HDD and then open access to both the IDE Primary Master and Access Mode fields.

IDE Primary Master/Slave [Auto]

IDE Secondary Master/Slave [Auto]

Select [Auto] to automatically detect an IDE hard disk drive. If automatic detection is successful, the setup BIOS automatically fills in the correct values for the remaining fields on this sub-menu. If automatic detection fails, this may be because the hard disk drive is too old or too new. If the hard disk was already formatted on a previous system, the setup BIOS may detect incorrect parameters. In these cases, select [Manual] to manually enter the IDE hard disk drive parameters. If no drive is installed or if you are removing a drive and not replacing it, select [None]. Configuration options: [None] [Auto [Manual]

Access Mode [Auto]

The default [Auto] automatically detects an IDE hard disk drive. Select [CHS] in coordination with the [Manual] setting of the IDE Primary Master in order to enter the Hard Disk Drive values manually.

Before attempting to configure a hard disk drive, make sure you have the correct configuration information supplied by the drive manufacturer. Incorrect settings may cause the system to fail to recognize the installed hard disk.

2-10

Chapter 2: BIOS information