Asus A8V-VM manual Chassis intrusion connector 4-1 pin Chassis, Aafp

9. Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either High Definition Audio or AC `97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.

AAFP

Azalia compliant	Legacy AC 97
definition	compliant definition

PRESENCE#

GND

A8V-VM LPORT1 RPORT1

A8V-VM Analog Front Panel Connector

RETUR	RETUR		outR	outL
SENSE1_	SENSE2_	AGND	+5VA Back line	Back line
PORT2 R	SENSE SEND PORT2 L	AGND	+5VA Line out R	NC Line out L

•We recommend that you connect a high-definition front panel

audio module to this connector to avail of the motherboard high- definition audio capability.

•If you want to connect a high-definition front panel audio module to this connector, make sure the Audio Controller item in the BIOS is set to [Enabled]. See page 2-22 for details.

10. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component

is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

+5VSB MB Chassis Signal GND

A8V -VM

CHASSIS

(Default)

A8V-VM Chassis Intrusion Connector

ASUS A8V-VM 1-29