DMA Mode [ Auto]

Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1] [SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4] [UDMA5] [UDMA6]

SMART Moni tori ng [ Auto]

Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration options: [Auto] [Disabled] [Enabled]

32Bi t Data Transfer [Enabl ed]

Enables or disables 32-bit data transfer.

Configuration options: [Disabled] [Enabled]

2.3.5 I DE Confi gurati on

The items in this menu allow you to set or change the configurations for the IDE devices installed in the system. Select an item then press <Enter> if you want to configure the item.

Parallel ATA IDE Controller

[Both]

Hard Disk Write Protect

[Disabled]

IDE Detect Time Out (Sec)

[35]

ATA(PI) 80Pin Cable Detection

[Host]

Parall el ATA I DE Controll er [ Both]

Allows you to select the Parallel ATA IDE controller. Configuration options: [Disabled] [Primary] [Secondary] [Both]

H ard Di sk Wri te Protect [ Di sabl ed]

Allows you to enable to disable the hard disk write protection. This will be effective only if device is accessed through BIOS. Configuration options: [Disabled] [Enabled]

I DE Detect Ti me Out (Sec) [ 35]

Allows you to select the time out value for detecting ATA or ATAPI device(s).Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]

2-16

Chapter 2: BIOS Information